DIY installation guide: How to replace 17.5 inch aluminum wheels!

It's inevitable that at some point, you'll need to replace the aluminum wheels on your vehicle. Whether it's due to wear and tear, damage, or simply wanting to upgrade to a new set, knowing how to properly replace them on your own can save you time and money. In this DIY installation guide, we'll walk you through the steps to replace 17.5-inch aluminum wheels on your vehicle.

Preparing for the Replacement

Before you start the process of replacing your 17.5-inch aluminum wheels, there are a few things you'll need to do to prepare. First, ensure that you have all the necessary tools and equipment on hand. This includes a set of jack stands, a lug nut wrench, a hydraulic jack, and your new set of 17.5-inch aluminum wheels. Additionally, it's important to work in a clean and well-lit area to ensure safety and accuracy during the installation process. Once you have everything ready, it's time to move on to the next step.

Removing the Old Wheels

The first step in the process of replacing your 17.5-inch aluminum wheels is to remove the old ones. Start by using the lug nut wrench to loosen the lug nuts on the wheels. Once the lug nuts are loosened, use the hydraulic jack to lift the vehicle off the ground, and then place the jack stands underneath for added support. With the vehicle securely supported, you can then proceed to fully remove the lug nuts and take off the old wheels. Be sure to set the lug nuts aside in a safe place, as you'll need them later in the installation process.

Installing the New Wheels

With the old wheels removed, it's time to install the new 17.5-inch aluminum wheels. Start by lining up the holes on the new wheels with the wheel studs on the vehicle. Once the holes are aligned, carefully slide the new wheels onto the studs. Once the wheels are in place, you can then begin to hand-tighten the lug nuts onto the studs. Be sure to tighten the lug nuts in a crisscross pattern to ensure that the wheels are secured evenly.

Tightening the Lug Nuts

After hand-tightening the lug nuts, it's important to properly tighten them to ensure that the wheels are securely fastened to the vehicle. Use the lug nut wrench to tighten the lug nuts in a star or crisscross pattern. It's crucial to follow the torque specifications provided by the manufacturer to prevent over-tightening, which can cause damage to the wheels or studs. Once all the lug nuts are properly tightened, you can then remove the jack stands and lower the vehicle back to the ground using the hydraulic jack.

Final Inspection and Testing

After the new 17.5-inch aluminum wheels have been installed, it's essential to conduct a final inspection and testing of the vehicle. Double-check that all the lug nuts are securely fastened and that the wheels are properly aligned. Take the vehicle for a short test drive to ensure that the new wheels are functioning correctly and that there are no unusual noises or vibrations. If everything checks out, congratulations - you've successfully replaced the 17.5-inch aluminum wheels on your vehicle!

In conclusion, knowing how to replace the 17.5-inch aluminum wheels on your vehicle can be a valuable skill that can save you time and money. By following the steps outlined in this DIY installation guide, you can easily and safely replace your aluminum wheels at home. Remember to always prioritize safety during the installation process and to refer to the manufacturer's instructions for any specific requirements. With the right tools and a bit of patience, you can have your new 17.5-inch aluminum wheels installed in no time. Happy driving!